Unless you’ve been living under a rock, you’ve heard of the Matco Exclusive Hyper-Step Drill Bits. With their ability to drill through nearly every task that is put in front of them, Hyper-Step sets are a must-have for every technician and should occupy nearly all toolboxes.
The patented Hyper-Step tip design cuts 45% faster and stays sharp 4X longer than standard bits, saving you time and the hassle of having to consistently replace dull drill bits. Less job time and extended life for mechanic tools means money in your pocket!
The DBC29HSRM 29 Piece Cobalt Hyper-Steps take conquering difficult jobs to the next level. This set comes in mechanic’s length which increases the drill bits rigidity and improves access to even the tightest spaces. Each bit also acts like a step drill. This spreads the job of cutting across multiple levels and keeps the drill bit cool while keeping the wear to a minimum and eliminating the need for pilot holes.
Cobalt drill material is perfect for use on the toughest jobs. Here are 5 jobs that could ruin your day with competitor drill bits but are absolutely no match for the Matco Exclusive Cobalt Hyper-Step bits.
-
- Stripped or broken off exhaust manifold studs, especially on a Ford 5.4 L
- Truck Frames
- Stainless steel
- Grade 8 fasteners or hardware exposed to heat often like exhaust
- Recessed broken bolts where normally starting a pilot hole would be almost impossible (these drill bits can do it in one shot, no pilot [centering] hole needed!)
Precision and performance are what the Cobalt Hyper-Step drill bit set brings for your shop equipment arsenal. The DBC29HSRM 29-piece set includes 1/16" through 1/2" by 64ths bits, providing the perfect size for the job at hand. There are three-flatted shanks on both sizes below 3/8" and 3/8" reduced shank sizes up to 1/2", allowing them to be compatible in standard chucks.
When the going gets tough, the tough get drilling! Nothing is tougher than the Cobalt Hyper-Step Drill Bits, exclusive to Matco Tools!
